Status Messages; Troubleshooting - Yamaha SP2060 Owner's Manual

References

Status messages

Message
Connecting
Download Success
Downloading
File Operating
Network Setup
Panel Locked
Panel Unlocked
Scene Recalling
Scene Storing
Cannot Recall
Cannot Store
NO X-OVER
NO LIMITER
Protected
Panel Protected
NO ROUTING
NO LEVEL
Network Busy
Synchronizing
Scene Deleting
* Do NOT turn off the power to the SP2060 while the unit displays the message "DO NOT TURN OFF!" at the bottom of the display.

Troubleshooting

Symptom
No communication between the
SP2060 and the DME Designer
application software.
No audio output.
The parameters cannot be edited.
Meaning
Connecting to the network.
The program has been successfully updated.
Program update in progress. Do NOT turn power off while the unit displays this message.
A file operation is in progress during which the computer manipulates scene data. Do NOT turn power off
while the unit displays this message.
Preparing network connection.
The User Lock function is engaged. The panel controls do not work.
The User Lock function has been disengaged. Panel operation is now possible.
Scene recall in progress.
Scene store in progress. Do NOT turn power off while the unit displays this message.
Recalling scenes or libraries is disabled.
The scene store is disabled.
Input channels do not feature the X-Over parameter.
Input channels do not feature the Limiter parameter.
You cannot edit or delete protected scenes.
If the User Lock function is turned on, you cannot change the parameters by using the panel controls.
Input channel SUM does not feature the Routing parameter.
Input channel SUM does not feature the Level parameter.
There is too much network traffic. Communication is very slow.
Data is being received from the computer. Do NOT turn power off while the unit displays this message.
Deleting a scene. Do NOT turn power off while the unit displays this message.
Possible Causes
The connection cable is not connected properly.
The computer's Ethernet port is not functioning
properly.
The DME-N Network driver has not been
installed.
The Mute function is turned on.
The output level is set too low.
The User Lock function is turned on.
Possible Solutions
Make sure that the cable is properly connected.
Refer to the DME Designer Installation Guide.
Install and set up the DME-N Network driver.
Turn off the Mute function (see page 36).
Increase the output level (see page 23).
Turn off the User Lock function (see page 33).
SP2060 Owner's Manual
45