Ctrl Assign1 (Controller Assign); Plg Midi (Plug-In Midi); Ctrl Assign2 (Controller Assign); Plg System (Plug-In System) - Yamaha S30 Owner's Manual

CTRL Assign1 (Controller Assign 1)
Use Knobs [C], [1] and [2] to assign Control Change
Numbers to the Breath Controller, Knob [1] and Knob
[2], respectively. The selected Control Change Name is
shown on the left of the display.
CTRL Assign1)
Vce [FootCtrl]
Control
Change Name
BC (Breath Controller)
Specify a Control Change Number for this
Assignable Controller. When MIDI information for
this Assignable Controller is received, the specified
Control Change is applied.
Settings: 00 ~ 95 (see the separate Data List for details)
Knob1/2 (Knob [1]/[2])
Assign Control Change Numbers to Knobs [1] and
[2] on the front panel.
Settings: 00 ~ 95 (see the separate Data List for details)
CTRL Assign2 (Controller Assign 2)
Use Knobs [C] and [1] to assign Control Change
Numbers to the Foot Controller and Ribbon Controller,
respectively. The selected function is shown on the left
of the display. Use Knob [2] to select the Ribbon
Controller Mode.
CTRL Assign2)
Vce [--------]
Control Change Name
FC (Foot Controller)
Assign a Control Change Number to the Foot Controller.
The Foot Controller is connected to the FOOT
CONTROLLER connector on the rear panel (Page 13).
Settings: 00 ~ 95 (see the separate Data List for details)
RB (Ribbon Controller)
Specify a Control Change Number for this Assignable
Controller. When MIDI information for this Assignable
Controller is received, the specified Control Change is
applied.
Settings: 00 ~ 95 (see the separate Data List for details)
Details about Controller Assign settings in Performance
Mode are given on Page 111.
BC Knob1 Knob2
02 16 17
Control
Change Number
FC RB
04 22
Control Change
Number
PLG (Plug-in) (if a Plug-in Board has been installed)
If you have a Plug-in Board installed, the following two
screens are available for setting its parameters.
However, the number of sub-screens and parameters will
vary depending on the type of Plug-in Board installed.

PLG MIDI (Plug-in MIDI)

PLG System (Plug-in System)

PLG MIDI (Plug-in MIDI)
Set the MIDI parameters of the Plug-in Board.
PLG MIDI)
PLG150-AN
Clock
Select whether or not to transmit MIDI Clock
messages to the Plug-in Board.
Settings: off, on
DevNo (Device Number)
Set the MIDI Device Number of the Plug-in Board.
This number must match the Device Number of the
external MIDI device when transmitting/receiving
bulk data, parameter changes or other system
exclusive messages to/from it.
Settings: 1 ~ 16, all, off
PLG System (Plug-in System)
Set the system parameters for each Plug-in Board. Use
Knob [C]/[2] to change the parameter. The number of
screens and parameters will vary depending on the type
of Plug-in Board installed. In the following example, a
PLG150-AN Plug-in Board has been installed in the
Plug-in slot.
PLG System) Vel Curve
Part Assign (assignment) for a Single-Part Plug-in Board is
fixed as follows:
• Voice Mode: 1
• Performance Mode: 15
133
Clock DevNo
on all
Mrph CtrlNo
norm off