Rcv Sw3 (Receive Switch); Part Controller; Rcv Sw4 (Receive Switch) - Yamaha S30 Owner's Manual

RCV Sw3 (Receive Switch 3)
When set to "on," each Voice in each Part will receive
volume, pan, sustain pedal, foot switch and Control
Change messages.
Parts 1 to 16
Plug-in Part
Multi Plug-in Part
Drum Voice Part
Settings:
Vol (Volume): off, on
Pan: off, on
Sus (Sustain): off, on
FS (Foot Switch): off, on
RCV Sw4 (Receive Switch 4)
When set to "on," each Voice in each Part will receive
Program Change and Control Change messages when
you change Performance Bank/Program.
Settings:
BankSel (Bank Select): off, on
PgmChng (Program Change): off, on
CtrChng (Control Change): off, on

Part Controller

You can set various Controller parameters for the Multi
Plug-in Parts 17 to 32. The following six screens for
the Multi Plug-in Part parameters are available.
CTL MW Control (MW Control Depth) (Multi Plug-in
Parts only)
CTL MW Modulation (MW Modulation Depth) (Multi
Plug-in Parts only)
CTL AT Control (AT Control Depth) (Multi Plug-in
Parts only)
CTL AT Modulation (AT Modulation Depth) (Multi
Plug-in Parts only)
CTL AC Control (AC Control Depth) (Multi Plug-in
Parts only)
CTL AC Modulation (AC Modulation Depth) (Multi
Plug-in Parts only)
CTL MW Control (MW Control Depth)
(Multi Plug-in Parts only)
The Modulation Wheel can be used to control Filter and
Amp parameters for each Multi Plug-in Part (17 to 32).
Filter
Set the amount by which the Modulation Wheel can
be used to adjust the filter's Cutoff frequency.
Settings: -64 ~ +63
Amp
Set the amount by which the Modulation Wheel can
be used to adjust the output level (amplitude).
Settings: -64 ~ +63
CTL MW Modulation
(MW Modulation Depth)
(Multi Plug-in Parts only)
The Modulation Wheel can be used to control the
amount of pitch/filter/amplitude modulation applied to
each Multi Plug-in Part (17 to 32).
PMod (Pitch Modulation Depth)
Set the amount by which the pitch modulation
changes when the Modulation Wheel is used.
Settings: 0 ~ 127
119