Multi Edit; Performance Program Selection - Yamaha S30 Owner's Manual

Performance Program Selection

There are four ways in which you can select a
Performance.
Using the BANK/PROGRAM keys
Using the [DEC/NO] and [INC/YES] keys
Using the [DATA] knob
Using the Category Search
Using the [INC/YES] and [DEC/NO] keys, the [DATA]
knob or the Category Search function is the same as
selecting the Voice directly in Voice Play Mode. Refer
to Page 60, replacing the word "Voice" with
"Performance."
Using the BANK/PROGRAM Keys
1Press the MEMORY [INT] or [EXT] key and select
the Performance Memory. The selected Performance
Memory indicator in the display will blink.
PRE1 PRE 2
DRUM
Details about Performance Memories are given on Page 24.
2Press a BANK key ([A] to [H]) to select a Bank.
The Bank indicator in the display will blink.
Press Bank keys [A] to [D] when selecting an EXT
Performance.
PRE1 PRE 2 INT EXT
DRUM DRUM
A B C
A. PIANO E. PIANO ORGAN GTR/BASS
1 2 3
9 10 11
If you press the [EXIT] key here, the Performance selection
process is canceled and the original Performance is
reinstated.
If the Bank has already been selected, this step is not
required.
Details about Banks are given on Page 24.
INT EXT PLG
DRUM
PLG
QUICK
ACCESS
D E F G H
STRINGS BRASS SYNTH OTHER
4 5 6 7 8
12 13 14 15 16
3Press a PROGRAM key ([1] to [16]) to select a
Program Number.
Performances can be selected by setting the Memory,
Bank and Program Number as explained in the three
steps given above. The display also shows the
selected Performance.
1 2 3
9 10 11

Multi Edit

(Volume, Pan, Reverb/Chorus
Send, Note Shift)
You can set the output level (volume), stereo pan and
other parameters for each Part using the graphic editors
on screens 3 to 7. You can, for example, adjust each
Part's Volume and Pan parameters in real-time while
using the synthesizer as a multitimbral tone generator
with a sequencer.
Method of Setting Up
The same procedure applies to screens 3 to 7.
SHIFT PAGE A
PART/ELEMENT
1 2
1Use the [PAGE] knob to select the screen.
2Use Knob [A] to select the Part. You can choose
from, PartPL (Plug-in Part), Part01 to Part16 (Voice
Part 1 to 16). Apart from the 7th screen (Note
Shift), the Common (Layer Common) parameters are
the same for all Layer Parts.
The parameter settings for each Part are shown as a
bar graph, giving you an idea of the overall sound
balance.
You can also use the MEMORY and PART keys on
the front panel to select each Part. The keys relate to
each Part as follows.
[PRE1/2] key ......................Common (Layer Common)
[PLG] key..............................PartPL (Plug-in Part)
PART keys [1] to [16] ................Part01 to Part16 (Voice Parts 1 to 16)
3Use Knob [B] or the [DATA] knob or the [DEC/NO]
and [INC/YES] keys to adjust the parameter settings
for each Part.
104
4 5 6 7
12 13 14 15
B C 1 2
3
8
16
DATA