Rear-Viewmirrors; Idleadjustment - PIAGGIO Liberty 50 4T Manual

THE PRESENCE OF DROPS OF WATER, ON THE OTHER HAND, COULD INDI-
CATE THAT WATER IS INFILTRATING. CONTACT THE AFTER-SALES SERVICE
NETWORK.

Rear-viewmirrors (03_21)

To adjust the stem position, lift the rubber protection and loosen the nut «A» with an
open wrench (opening 13 mm); adjust the stem to the best position and tighten the
screw. The rear-view mirror is fitted on a stem with a ball "joint" «B». The mirror can
be adjusted to the desired position manually.
03_21

Idleadjustment (03_22)

Tickover can be adjusted by turning the idle speed screw "D" on the carburettor. To
take up any play in the throttle cable, use the adjuster "E" Adjust tickover when the
engine is warm. Make sure the rear wheel is off the ground by using the main stand.
Screw or unscrew the adjuster until the engine is idling and the rear wheel is not
turning.
You are advised to make this adjustment at your nearest Authorised PIAGGIO
Dealer's.
03_22
SHOULD THERE BE PROBLEMS DURING THE IDLE SPEED ADJUSTMENT OP-
ERATION, IT MAY BE NECESSARY TO ADJUST THE LEVEL OF EXHAUST
41