Frontdirectionindicators; Rearopticalunit - PIAGGIO Liberty 50 4T Manual

«A» on the front of the unit as shown in figure 1. Before adjusting the headlamp angle,
make sure the tyres are inflated to the pressure specified on pneumatic section.
03_18

Frontdirectionindicators (03_19)

Use a Phillips screwdriver on the screw «C» shown in the figure. The bulb has a
bayonet fitting, to remove it press gently, and turn it anticlockwise about 30° and then
withdraw it. To refit follow the same steps but in reverse order.
03_19

Rearopticalunit (03_20)

To access the taillight, remove the 2 screws «D» that secure it. To access the turn
indicator bulbs remove screws «E». The bulbs have a bayonet coupling, to remove
them press gently and twist counterclockwise about 30°. To reassemble the parts
follow the above steps on the opposite order.
N.B.
03_20
IF MISTING IS NOTICED ON THE INSIDE OF THE HEADLAMP GLASS, THIS
DOES NOT INDICATE A FAULT AND IS ATTRIBUTABLE TO HUMIDITY AND/OR
TO LOW TEMPERATURES.
THE PHENOMENON SHOULD QUICKLY DISAPPEAR WHEN THE LIGHT IS
SWITCHED ON.
40