Cisco 7500 Series Replacing Manual page 22

Replacing the CI in the Cisco 7513
Replacing the CI in the Cisco 7513
The following procedures describe how to replace the CI in the Cisco 7513. Depending on your
installation, you might need to remove the Cisco 7513 from the rack in which it is installed. You
must first remove the chassis covers, then remove the backplane maintenance cover, and then you
can replace the CI.
Removing and Replacing the Chassis Cover Panels
Each cover panel has four fasteners that secure the panels to the front of the chassis. The following
procedures describe how to remove and replace the front cover panels on the Cisco 7513 chassis.
Warning
the power cord. (For a translation of this safety warning, refer to the section "Translated Safety
Warnings" on page 32.)
22 Replacing the Chassis Interface (CI) Board in the Cisco 7500 Series Chassis
Before working on a system that has an on/off switch, turn OFF the power and unplug