Body Back Panel - Polaris GEM E Series Service Manual

BODY BACK PANEL

DESCRIPTION
The body back panel is made of molded plastic.
The two, four and six passenger models have a cut
out to accommodate the Trunkback/Golfback/Clip-
In Stake Bed latch assembly.
Fig. 4 Body Back Panel (eS, eL, eLXD, e6S
without cutout)
November 2007
REMOVAL
ALL
1. Remove the spat or utility bed. See Spat or
Utility Bed in this section.
2. Remove Trunkback/Golfback/Clip-In Stake Bed
handle (if equipped).
Note: Not available on eS, eL, eLXD and e6S
models. See Trunkback/Golfback/Clip-In Stake
Bed Handle in this section.
3. Drill out rivets, or remove rear bolts, depending
on vehicle.
4. Remove body side panels. See Body Side
Panel in this section.
5. Remove bench seat base and seat back. See
Bench Seats in this section.
6. Remove two (2) Tek screws holding the
mounting brackets to the back panel attached
to the frame rails using a 3/8" driver.
7. Disconnect taillight/brake light electrical if
necessary for brake chimsel light and taillights.
8. Remove body back panel.
INSTALLATION
1. Install the body back panel.
2. Install the 2 Tek screws (one on each side of
panel).
3. Connect taillights/brake
connectors (if equipped).
4. Install body side panels. See Body Side Panel
in this section.
5. Install the Trunkback/Golfback/Clip-In Stake
Bed handle and adjust as necessary. See
Trunkback/Golfback/Clip-In Stake Bed Handle
Adjustment in this section.
6. Install Spat. See Spat or Utility Box in this
section.
BODY 7 - 10
lights electrical
GEM Service Manual