Installation - bioBidet BB-800 Installation Manual And Operating Instructions

Bio Bidet
ELECTRONIC BIDET TOILET SEAT
6

INSTALLATION

CAUTION BEFORE INSTALLATION
•Do not connect to electricity before water connection.
•If you need an electric power system or extension, please consult a qualified electrician.
STEPS
1
Shut off the water supply to the
existing toilet tank by closing the
angle stop valve. Drain the toilet
tank completely by flushing toilet.
Remove the water supply hose to
toilet tank.
Existing Flexible Tube
(The water supply hose)
3
Remove existing supply pipe from the cistern tank and connect the tee to the cistern tank.
Connect the double check valve supplied to the tee and the 1/2" male-male adaptor to the
check-valve. Connect existing supply pipe to the tee.
An approved double-check valve must be installed on the inlet connection to this device.
Thread from tank
Existing Flexible Tube
(The water supply hose)
※Check for any water leaks.
(TEFLON tape is strongly recommended around threads to help prevent leakage)
14
Installation Manual and Operating Instructions
2
Removing the existing seat and lid.
•Release the nuts on both sides of existing toilet
seat to remove the seat and lid.
DOUBLE CHECK VALVE MUST
COMPLY WITH THE UK WATER
REGULATION
4
Installation Base Assembly.
1. Put the 2 Bolts into the 2 Installed Bolt Cases
2. Place this Bolt assembly into the Installation
Base as shown.
3. Guide Arrows on the Installation Base should
face up and towards the Toilet Tank.
4. Place the Installation Base and guide the Bolts
into the 2 holes on the toilet bowl.
Bolt Case
Bolt
Intallation Base
6
Bio Bidet Shower Toilet Seat Assembly.
1. Slide the seat onto the installation Base centering
the unit with the guide arrows on the Base.
2. You will hear a click once the seat is securely
mounted to the Installation Base.
3. The seat will feel a little loose on the toilet bowl.
Adjust the fit from front to back and side to side for balance.
4. Tighten the nuts on both bolts securely.
※Check for any water leaks.
(TEFLON tape is strongly recommended around threads to help prevent leakage)
ELECTRONIC BIDET TOILET SEAT
5
Bolt and Nut Assembly.
1. Fit the cone packing and plastic washers onto
the bolts from below the toilet bowl as shown.
2. Loosely tighten nuts by hand.
Cone Packing
Washer
Nut
7
Water Supply Tube Assembly.
1. Connect the flexible tube from male-male
Adaptor to the seat.
2. Open the water valve.
3. Check for leaks.
4. If there are no leaks and the surrounding
area is clean and dry, connect the power
cord to a ground protected power outlet.
ADAPTOR
CHECK
VALVE
15
Installation Manual and Operating Instructions