OPERATION (CONT.)
19. Nozzle Cleaning (Automatic & Manual)
Automatic
•
This product has an automatic
nozzle self-cleaning function
that cleans the nozzle before
and after each use.
20. Selecting/Canceling Silent Mode
•
Beeping mode can be
enabled or disabled.
•
To select or cancel silent mode,
press and hold down the "Stop"
and "Massage" remote buttons
simultaneously for approximately
3 seconds or until short beeps
•
Single short beep - Silent mode
has been canceled
•
Double short beeps - Silent mode
has been set
•
The new setting will automatically
be saved if no other buttons
are pressed.
24
Manual
•
Press the "Posterior"
button on the Auxiliary
Control panel on the
side of the seat without
occupying seat. The
nozzle will fully extend.
Gently clean the nozzle
with a soft cloth or
toothbrush.
•
Press "Stop" button to
retract nozzle to stand
by mode.
INSTALLATION
•
Do not plug in before
installation.
•
If you need an electric power
system or extension, please
consult a qualified electrician.
•
Please contact our service
center (847-458-2334) when
you want to reinstall the
bidet product (move
or replacement).
2.
Remove Existing
Seat & Lid
•
Remove mounting bolts to
release existing toilet seat
from toilet.
1.
Turn Off Water
•
Shut off the water
supply shut off valve.
•
Drain the toilet
tank completely.
•
Then remove the
existing fill valve
water supply hose.
3.
Connect T-Valve
•
Remove existing supply
hose connected to the
toilet tank. Make sure
not to damage the water
supply hose.
•
Install T-Valve at the
thread from tank.
25