Yamaha Midi XG MU90R Sound List page 18

Since this is a relative change parameter, it specifies an increase or decrease centered at
64.
Higher values will lengthen the release which occurs after note-off.
1.2.14 Attack Time
This message adjusts the EG Attack Time specified by the sound.
Control# Parameter
73 Attack Time
Since this is a relative change parameter, it specifies an increase or decrease centered at
64.
Higher values will make the attack more gradual, and lower values will make the attack
more sharp.
1.2.15 Brightness
This message adjusts the low pass filter cutoff frequency specified by the sound.
Control# Parameter
74 Brightness
Since this is a relative change parameter, it specifies an increase or decrease centered at
64.
Lower values will produce a more mellow sound.
For some sounds, the effective range may be narrower than the settable range.
1.2.16 Portamento Control
This message specifies the key source number for portamento (the key number from
which portamento will start). The portamento source key is specified as 0...127.
When Portamento Control is received, the currently sounding pitch will change at a speed
of Portamento Time 0 to the key of the next note-on that is received on the same channel.
Control# Parameter
84 Portamento Control
This is received even if Rcv PORTAMENTO = OFF.
1.2.17 Effect1 Depth (Reverb Send Level)
This message specifies the send level for the reverb effect.
Control# Parameter
91 Effect1 Depth
Higher values will produce a deeper reverb. The result of the value will depend on the
state of the reverb effect.
1.2.18 Effect3 Depth (Chorus Send Level)
This message specifies the send level for the chorus effect.
Control# Parameter
93 Effect3 Depth
Higher values will produce more modulation and spaciousness. The result of the value
will depend on the state of the chorus effect.
1.2.19 Effect4 Depth (Variation Effect Send Level)
This message specifies the send level for the variation effect.
Control# Parameter
94 Effect4 Depth
However, this is not received if the Variation Effect parameter Variation Connection = 0
(Insertion).
1.2.20 Data Increment / Decrement (for RPN)
This message increases or decreases the value of the parameter specified by RPN (see
1.2.22) in units of 1.
Control# Parameter
96 RPN Increment
97 RPN Decrement
The data byte is ignored.
1.2.21 NRPN (Non-registered Parameter Number)
These messages are used to set parameters such as vibrato, filter, EG, or drum setup etc.
The parameter is specified by transmitting a NRPN MSB and NRPN LSB, and subse-
quently Data Entry (see 1.2.4) is used to set the value of the specified parameter.
Control# Parameter
98 NRPN LSB
99 NRPN MSB
When the Multi Part parameter Rcv NRPN = OFF, NRPN for that part will not be re-
ceived. The following NRPN messages can be received.
MIDI Data Format
Data Range
0...64...127
(-64...0...+63)
Data Range
0...64...127
(-64...0...+63)
Data Range
0...127
(C-2...G8)
Data Range
0...127
Data Range
0...127
Data Range
0...127
Data Range
--
--
Data Range
0...127
0...127
NRPN Data Entry*1
MSB LSB MSB LSB Parameter name and range of values
01H 08H mm -- *2 Vibrato Rate
mm : 00H - 40H - 7FH (-64...0...+63)
01H 09H mm -- Vibrato Depth
mm : 00H - 40H - 7FH (-64...0...+63)
01H 0AH mm -- *3 Vibrato Delay
mm : 00H - 40H - 7FH (-64...0...+63)
01H 20H mm -- Low Pass Filter Cutoff Frequency
mm : 00H - 40H - 7FH (-64...0...+63)
01H 21H mm -- Low Pass Filter Resonance
mm : 00H - 40H - 7FH (-64...0...+63)
01H 24H mm -- High Pass Filter Cutoff Frequency
mm : 00H - 40H - 7FH (-64...0...+63)
01H 30H mm -- *4 EQ Bass Gain
mm : 00H - 40H - 7FH (-64...0...+63)
01H 31H mm -- *4 EQ Treble Gain
mm : 00H - 40H - 7FH (-64...0...+63)
01H 34H mm -- *4 EQ Bass Frequency
mm : 04H - 28H (32...2.0k[Hz])
01H 35H mm -- *4 EQ Treble Frequency
mm : 1CH - 3AH (500...16.0k[Hz])
01H 63H mm -- EG Attack Time
mm : 00H - 40H - 7FH (-64...0...+63)
01H 64H mm -- EG Decay Time
mm : 00H - 40H - 7FH (-64...0...+63)
01H 66H mm -- EG Release Time
mm : 00H - 40H - 7FH (-64...0...+63)
14H rr mm -- Drum Low Pass Filter Cutoff Frequency
rr : drum instrument note number
mm : 00H - 40H - 7FH (-64...0...+63)
15H rr mm -- Drum Low Pass Filter Resonance
rr : drum instrument note number
mm : 00H - 40H - 7FH (-64...0...+63)
16H rr mm -- Drum EG Attack Rate
rr : drum instrument note number
mm : 00H - 40H - 7FH (-64...0...+63)
17H rr mm -- Drum EG Decay Rate
rr : drum instrument note number
mm : 00H - 40H - 7FH (-64...0...+63)
Applies to both Decay 1 and 2
18H rr mm -- Drum Instrument Pitch Coarse
rr : drum instrument note number
mm : 00H - 40H - 7FH (-64...0...+63)
19H rr mm -- Drum Instrument Pitch Fine
rr : drum instrument note number
mm : 00H - 40H - 7FH (-64...0...+63)
1AH rr mm -- Drum Instrument Level
rr : drum instrument note number
mm : 00H - 7FH (0...maximum)
1CH rr mm -- Drum Instrument Panpot
rr : drum instrument note number
mm : 00H,01H-40H-7FH (RND, L63...C...R63)
1DH rr mm -- Drum Instrument Reverb Send Level
rr : drum instrument note number
mm : 00H - 7FH (0...maximum)
1EH rr mm -- Drum Instrument Chorus Send Level
rr : drum instrument note number
mm : 00H - 7FH (0...maximum)
1FH rr mm -- Drum Instrument Variation Send Level
rr : drum instrument note number
mm : 00H - 7FH (0...maximum)
when Variation Connection = SYSTEM
mm : 00H, 01H-7FH(OFF,ON)
when Variation Connection = INSERTION
17