Monitor Section - Yamaha EMX62M Owner's Manual

M
Peak level indicator
This indicator indicates the level of the signal
output from the MAIN OUTPUT jack (input/
output panel 9). Adjust the MASTER control B
so that this indicator lights up only momentarily
to avoid distortion.
N
LIMITER indicator
The LIMITER indicator lights up when the lim-
iter circuit, which is designed to protect the inter-
nal power amplifier against excessive input
signals and load mismatches, activates.
Note: Do not let the LIMITER indicator light
up or flash for a long period of time. Otherwise,
the power amplifier would be under excessive
loads, which might lead to a malfunction of the
unit.

MONITOR Section

The MONITOR section is used to set the MONI-
TOR MASTER level and MONITOR EFFECT
RTN level.
E
O
EFFECT RTN control
The MONITOR EFFECT RTN control deter-
mines the level of the signal from the built-in dig-
ital effects processor that is fed to the MONITOR
bus and subsequently the MONITOR OUTPUT.
P MASTER control
The MONITOR MASTER control determines the
output level of the MONITOR OUTPUT.
PHANTOM switch and indicator
Q
PHANTOM switch and indicator
This switch turns the phantom power supply on/
off for the Low-Z input jacks of channels 1–4.
When the switch is turned on, the indicator lights
up.
Turn this switch off if you do not use it.
YAMAHA SPEAKER PROCESSING
R
ON/OFF switch
This switch enables you to compensate the low
range of the speakers. The low range balance
when this switch is on varies depending on the
speakers.
First, check the low range balance by auditioning
the resultant sound, then set this switch to on or
off.
F
Power switch and indicator
S
Power ON/OFF switch and indicator
This switch turns the power of the EMX62M on/
off. When the switch is turned on, the indicator
lights up.
Note: Before turning the EMX62M on/off, turn
down the MASTER controls of the MONITOR
and MAIN section.
11
Front & Rear Panels
G
H
I
EMX62M—Owner's Manual