4.
Height adjustment
To adjust the desk height, loosen
the wing nut slightly and press
inwards.
Adjustment is made at 10 mm inter-
vals, in the range 680-820 mm, as
indicated on the scale.
When the desk is at the desired
height, tighten the wing nut.
5.
Wire management
Attach the umbilical using the
sprung clamp across the slot in
the cable tray, and run the cable
through the umbilical into the
tray.
The cable tray bracket are
clamped to the frame. They are
used on desks without a sliding
top and on link desks.
The cable clips are clipped
onto the frame from the side or
from below.
6.
Fitting a side extension
frame or a printer tray.
The extension frame and the
printer tray are fastened to the
frame of the main desk. The con-
nector is locked into the slot in
the frame by a wing nut from
below.
10