Advertisement
Available languages
Available languages
1.
Set up the desk
Unclip the leg Πfrom the trans-
port clip ) and lift through 90°.
Push the butto Ž on the node
down, push the node into the
main beam until the knob locates
in the second hole.
Tighten the wing nut.
Fasten the transport clip to the
main beam.
2.
Fitting the legs
(where shipped separately)
Push the node Πof the leg into
the main beam of the desk.
The button Ž on the underside of
the node must locate in the
second hole on the beam.
By tightening the wing nut , the
leg is given greater stability.
With link modules , the leg is
fastened from below with a wing
nut .
3.
Fitting and using the
sliding top.
Slide the clips on the top to the
"open" position, place the top on
the frame, slide the clips closed.
Pull the centrally located handle
down to release the safety catch.
The handle locks in position when
the top is closed. The top can only
be removed in the open position.
open
closed
9
Advertisement
