Connecting To A Usb-Type Lan Adaptor And Usb Storage Device (9 Via The [Usb To Device] Terminal) - Yamaha Clavinova CVP-401 Owner's Manual

The second connection possibility involves a separate,
external MIDI interface connected to the computer via a
USB port or a serial port (modem or printer terminal).
Using standard MIDI cables, connect the MIDI OUT ter-
minal of the external interface to the [MIDI IN] terminal
of the instrument, and connect the [MIDI OUT] terminal
of the instrument to the MIDI IN terminal of the interface.
[MIDI IN]
Instrument
terminal
[MIDI OUT]
terminal
n
Make sure to use the appropriate MIDI interface for your computer.
Connecting to a USB-type LAN Adaptor
and USB Storage Device
(9 via the [USB TO DEVICE] Terminal)
There are two ways of using the [USB TO DEVICE] ter-
minal.
■ By connecting the USB-type LAN adaptor, you can
directly access special Internet websites for down-
loading music data (page 172).
■ By connecting the instrument to a USB storage
device with a standard USB cable, you can save data
you've created to the connected device, as well as
read data from the connected device.
n
About the [USB TO HOST] and [USB TO DEVICE] terminals
There are two different types of USB terminals on the instrument:
[USB TO HOST] and [USB TO DEVICE]. Take care not to confuse
the two terminals and the corresponding cable connectors.
Be careful to connect the proper plug in the proper direction.
Explanations on the [USB TO HOST] terminal can be found in the
previous section.
Using USB Storage Devices
This type is used to connect the instrument to a USB
storage device, and allows you to save data you've cre-
ated to the connected device, as well as read data from
the connected device. The following description gener-
ally explains about how to connect and use them.
Before using a USB storage device, be sure to read
"Handling the USB Storage Device (USB Flash Mem-
ory/Floppy Disk, etc)" on page 22.
1
Connect the USB storage device to the [USB TO
DEVICE] terminal with a standard USB cable.
2
After that, exit once from the selection display
then return to the display (or press the Tab
switch buttons [√] and [®] simultaneously from
the selection display). The USB tabs (USB 1, USB
2, etc.) are automatically called up, allowing you
to save files and play back music data from the
devices.
USB port or serial
port (modem or
MIDI cable printer terminal)
MIDI interface
Computer
Connecting a Computer or USB Device
n
Checking remaining memory on the USB storage device
You can check this in the display called up by the following oper-
ation:
[FUNCTION] → [J] UTILITY → TAB [√][®] MEDIA
Select the device by using the [A]/[B] buttons in this display and
press [F] (PROPERTY).
n
Even with a computer connected to the [USB TO HOST] terminal
and a USB storage device connected to the [USB TO DEVICE] ter-
minal, you cannot access the USB storage device from the com-
puter via the instrument.
Formatting USB storage media
For details, see page 69.
CAUTION
Formatting a USB storage media completely erases all
data on the media. Make sure that the USB storage media
you're formatting does not contain important data!
Backing up your data to a computer
■ Backing up the instrument data to a computer
Once you've saved data to a USB storage device, you can
copy the data to the hard disk of your computer, then
archive and organize the files as desired. Simply recon-
nect the device as shown below.
Saves internal data to a USB storage device.
Computer
Instrument
Disconnect the USB storage device from the instrument and
connect it to the computer
Backing up data to a computer and organizing files/folders
Computer
Instrument
CVP-405/403/401 Owner's Manual
USB storage device
USB TO DEVICE terminal
USB storage device
191