Appendix; Message List - Yamaha CP300 Owner's Manual

Message List

Appendix

Message List
The messages are listed in alphabetical order.
Message
BulkDataReceiving
Completed
BulkDataReceiving
Error
BulkDataReceiving
BulkDump
Completed
DataFmtErr
DuplicatedName
Execute?-->
Executing
FactorySet Completed
MemoryFileExcluded
FactorySet Completed
MemoryFileIncluded
94
CP300 Owner's Manual
Bulk data reception has been completed.
This is shown following the "Bulk Data Receiving Voice" message. This indicates that the
instrument finished receiving bulk data, and that you can go on to the next step.
Bulk data reception has failed.
Check that the cable connection is secure and try again.
The instrument is receiving bulk data while this message is displayed.
Wait until the message closes, then go on to the next step.
The instrument failed to transmit the bulk data.
Error
If this message appears, make sure that the power of your computer has not been turned
off, that the cable is connected correctly, and that the driver on your computer is functioning
correctly. Then try transmitting the data once again.
This is shown when the operation has been canceled.
Canceled
The operation is completed.
This is shown following the "Executing" message. The instrument's internal processing is
complete. You can go on to the next step.
The file format is invalid.
This message appears when the Performance file selected via "Load From Mem." (page 79)
is invalid and cannot be called up.
The Song name or Performance name is duplicated.
You tried to save a Song file after changing its name using the "Rename Song" (page 83), or
a Performance file after changing its name using the "Rename File" (page 80) parameter,
but a Song or Performance with the same name already exists in memory. The instrument
returns to the previous display after three seconds. Rename the Song correctly.
Do you wish to execute the operation?
This message prompts you to execute a file-related operation. Press the B [+ (YES)] button
to save the settings. Press the B [– (NO)] or [EXIT] button to cancel.
The instrument is processing the data internally.
Wait until the message closes, then proceed to the next step.
The factory default settings, excepting files stored to storage memory (refer to
"Factory Set" on page 71), have been restored.
This message also appears if you press and hold down the C7 key and turn on the power to
the instrument (page 17).
The factory default settings, including files stored to storage memory (refer to
"Factory Set" on page 71), have been restored.
This message also appears if you press and hold down the C7 and Bb6 keys and turn on the
power to the instrument (page 17).
Description