Table of Contents
Advertisement
Available languages
Available languages
Lift Rod
Assembly
Rod
17-3/4"
Nut
(45.1 cm)
6. Install the Overflow Hood
Ensure the length from the eye to end of the spring is 17-3/4"
(45.1 cm). To adjust the length: Loosen the nut on the rod, adjust
the rod, then retighten the nut.
NOTE: In order for the drain to function properly, assemble the lift
rod with the crank at the 8 o'clock position as illustrated.
Slide the lift rod eye and washer onto the crank, as illustrated.
Secure the lift rod eye and washer with the cotter pin.
Using a pliers, close the cotter pin.
NOTE: If the handle is not pre-assembled to the overflow hood,
secure the handle to the overflow hood with the provided screw at
this time.
Angle the lift rod assembly to the side, as illustrated, then insert
it into the overflow of the bath.
Using a Phillips screwdriver, secure the overflow hood to the
overflow ell with the screws provided.
NOTE: If the overflow hood will be exposed to high volumes of
direct water spray, apply silicone sealant around the overflow hood.
This will create a watertight seal.
Kohler Co.
Overflow Hood
Screws
Handle
9
Overflow Hood
Cotter Pin
Lift Rod Eye
Brass
Washer
1054248-2-B
Advertisement
Table of Contents
