Advertisement
20.) Place the Entray Tray into the Frame as shown ensuring that the Tray slides back into the Frame,
mates with the electrical plug, and the retaining clips are engaged fully with Frame (See Figures 32 &33).
Figure 33
NOTE: REPEAT STEPS 3 -19 (SKIPPING 4 & 5) FOR TRAYS B & C IF NECESSARY.
IF NOT GO TO STEP 20.
IMPORTANT: IN DN55## VENDERS THE "A" TRAY LOCATION HAS TO BE A 5
COLUMN ENTRAY SHELF.
Start Tray Wheels on angled flange of
Frame. Push Tray back until it drops
into guide channel in Frame, then
push Tray back until Retaining Clips
engage with Frame.
Retaining Clip
Figure 32
Frame Electrical Plug
Tray Electrical Plug
Frame and Tray Plugs
mate to provide electrical
power to the Tray Motors
Page 17 of 34
Advertisement
