Beater; Remove The Accessory Part (Figure A); Operation; Operating Times - Silvercrest SSMS 600 C3 Operating Instructions Manual

5.3 Beater

Mount the beater (Figure A)
1. Attach the motor unit 2 to the beater
adapter 4 such that the attachment mark-
ing 16 is below the symbol
2. Turn the motor unit 2 such that the attach-
ment marking 16 on the motor unit
points to the lock marking
tor unit 2 must engage noticeably.
3. Attach the beater 6 to the beater adapt-
er 4 until it engages audibly and notice-
ably.
5.4 Remove the accessory
part (Figure A)
• To remove the accessory part, turn the
motor unit 2 such that the attachment
marking 16 points to the delock
marking 15 and pull off the motor
unit 2 from the accessory.
8
GB

6. Operation

DANGER! Risk of injury from
cutting!
Never reach into the rotating blades.
15.
Do not touch rotating parts with spoons
or similar utensils. Keep long hair or
loose clothing away from rotating parts
15. The mo-
as well.
Only switch on the device when the
blender 10 is immersed in the foodstuff.
The blade continues to rotate after the
device is switched off. Wait until the
blender 10 stops moving before you
take it out of the food.
WARNING!
The device is designed for a maximum
operating time of 2 minutes without in-
terruption (see "Operating times" on
page 8).
In order to prevent damage to the de-
vice, interrupt the blending process im-
mediately if the blade is either turning
with difficulty or not turning at all. Pull
out the mains plug 1 and check whether
there is something in the bowl blocking
movement or whether the food is too
tough. Also check whether the device is
assembled correctly.

6.1 Operating times

We recommend the following operating
times for the three applications:
- Blender up to 1 minute without inter-
ruption, then 2 minutes break
- Chopper up to 1 minute without inter-
ruption, then 5 minutes break
- Beater up to 2 minutes without inter-
ruption, then 2 minutes break