SD_D2
FX3_DQ3
SD_D3
FX3_DQ1
UART_RX
FX3_DQ0
3
UART_TX
FX3_DQ2
GND
USB_DP
USB_DM
USB_VBUS
USB_ID
GND
ETH_A_N
ETH_A_P
ETH0_LED1#
ETH0_LED2#
ETH_B_N
ETH_B_P
ETH_CTREF
ETH_C_N
ETH_C_P
ETH1_LED1#
ETH1_LED2#
ETH_D_N
ETH_D_P
GND
VCC_3V3
VCC_3V3
2.8.2
J400 – USB 2.0 Micro-B Connector
The USB 2.0 Micro-B Connector J400 allows simple RS232 communication between a host computer
and the Mars PM3 board using the USB interface. The USB 2.0 UART device U401 can be accessed
from the host computer using a virtual COM port driver to display debug messages or sending control
commands to the Mars PM3 board. The UART device is connected to the Mars module and the FX3
controller; make sure that the RX line is only driven by one device!
Normally the USB UART is connected to pins 34 and 36 of the Mars connector like the previous
versions of the Mars PM3. If DIP switch 4 of CFG-B is set to ON the UART will be routed to pins 153
23/04/2019
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
Table 5: J200 – Mars module connector
16 / 43
FX3_DQ4
FX3_DQ6
FX3_DQ5
GND
JTAG_TCK
JTAG_TDI
JTAG_TMS
JTAG_TDO
USB_CPEN
RSVD_P168
RSVD_P170
GND
I2C_INT#
I2C_SDA
I2C_SCL
GND
FLASH _CLK
FLASH_DO
FLASH_DI
FLASH_CS#
BOOT_MODE
SRST#_RDY#
FPGA_DONE
POR#_LOAD#
VMON_P198
VBAT
SD-Card detect
BOOT_MODE1
Version 1.09
Need help?
Do you have a question about the Mars PM3-R5 and is the answer not in the manual?