St (Stereo) Section - Yamaha GA24/12 Owner's Manual

ST (Stereo) section

This section enables you to control the ST bus signals output from the ST1 OUT jacks (see
page 17, rear panel
A
POST ST1 (Post stereo 1) switch
This switch toggles between pre- and post-fader for signals output from the ST2 OUT jacks.
1 When you turn this switch on, signals that passed the ST fader are output from the ST2 OUT
POST ST1
jacks. When you turn the switch off, the ST fader setting does not affect signals output from the
ST2 OUT jacks.
2
B
MONO (Monaural) switch
MONO
When you turn this switch on, the ST bus signals will be mixed into a monaural signal and
output from the ST2 OUT jacks. This switch setting does not affect signals output from the ST1
LEVEL
3
OUT jacks.
0 10
ST2
C
LEVEL control
This control enables you to adjust the output level of signals at the ST2 OUT jacks. It does not
AFL
4
affect the level of signals output from the ST1 OUT jacks.
10
D
AFL (After-fader Listen) switch
5
When you turn this switch on, the ST bus post-fader signals are routed to the AFL bus, and you
0
can monitor the signals via the C-R MONITOR OUT jacks or PHONES jack.
5
5
E ST (Stereo) fader
10
This fader enables you to adjust the final output level of the ST bus signals. This fader setting
20
affects the level of the signals routed to the ST1 OUT jacks, ST2 OUT jacks (when the POST
30
ST1 switch is turned on), and the AFL bus.
40
50
60
ST1
9
) and ST2 OUT jacks (see page 17, rear panel
ST
L R
ST
INSERT
I/O L
ST
INSERT
I/O R
Signal flow in the ST section
J
L
REC
OUT
R
L
ST1
OUT
R
AFL
L
POST
MONO LEVEL
ST1
ST2
OUT
R
GA32/12, GA24/12—Owner's Manual
9
ST (Stereo) section
).
AFL
L R