Battery Installation; Ac Adapter Use; Quick Start Instructions - Health O Meter PROPLUS User Instructions

BATTERY INSTALLATION / REPLACEMENT
®
1. Unplug the ProPlus
2. Using a Phillips screwdriver remove the battery cover from the display (A).
3. Disconnect battery holder cable connector from the scale-battery connector (B).
4. Carefully remove the battery holder by sliding it out of the display assembly (C).
5. Replace the batteries with new ones. *
6. Carefully position the battery holder into the display assembly.
7. Connect the battery holder cable connector to the scale-battery connector and carefully slide the bat-
tery holder into the display assembly.
8. Attach the battery cover to the display assembly and install the screw.
* We recommend the use of EVEREADY Energizer

AC ADAPTER USE

®
The ProPlus display has been designed to operate on
9V DC and ships with an AC Adapter (APDT31). To
operate the display using the AC adapter, insert the
adapter into the jack located on the rear of the display.
Use only a Health o meter
®
the ProPlus display.

QUICK START INSTRUCTIONS

1. Make sure there is no object on the weighing platform.
2. Press the ON/OFF of I/O button to turn the display on.
3. Wait until ― 0.0 lb‖ and ― ZERO‖ on the left side of the display appear.
4. Ask the patient to step on the scale. The display will read ― WEIGHING‖ until the weight calculation is
complete and the weight is displayed. Depending on the movement of the patient on the scale, it
may take several seconds for the scale to lock onto the weight.
5. If you wish to reweigh without asking the patient to step off and on the scale again, press the
REWEIGH button.
6. Ask the patient to step off the scale.
NOTE: The scale will always default to the settings and units last used.
WARNING: If the scale will not be used for a prolonged period of time, remove the batteries to avoid a
safety hazard.
display from all power sources.
®
Professional adapter with
WEIGHING A PATIENT
® TM
e2
POWER SUPPLY JACK
7
batteries.