Health O Meter PROPLUS User Instructions page 18

OPERATION INSTRUCTIONS
02 USB Connection
02-USB Connection
Connection
Is OK
Exit
03 Diagnostic Test
03-Diagnostic Test
Please Press
1 ...
Exit
03-Diagnostic Test
Please Press the
button marked 1 ...
(you have 10 seconds)
Exit
UI Error
Failure!
07 USER SETTINGS
Before making any changes to this display's settings, please refer to Menu instructions to temporarily
activate the Menu key.
Main Menu
06-System Settings
07-User Settings
→
08-Exit
▼▲ to change Enter
The display will test the connection to the computer and will show
a message ―Conne ction is OK‖ or ― NO Connection‖.
If ― NO Connection‖ is shown, check your USB connections to the
display and your computer and retest the connection. Refer to
qualified service personnel if problem persists.
The display has a diagnostic routine where it tests the User Interface
(UI) hardware functionality (LCD, keypad). In order to do this the
user has to press all the keys according to the messages displayed
on the screen.
Enter
If the requested command was not received or the wrong button was
pressed, the following message will be displayed.
Enter
If after 10 seconds the requested command was not received, the
following message will be displayed. If ― UI Error Failure‖ is dis-
played, refer to qualified service personnel.
▲
▼
07-User Settings
→
01-Retain Values
02-Disp Height & ID
03-Prompt For Height
▼▲ to change
04-Prompt for ID
05-Exit
18
▲
▼
Enter