Wiring Diagram - Makita DHR165 Technical Information

W
iring diagram
Fig. D-2
If Line filters are used, fix Lead wires
(black, red) of Endbell complete
in Lead wire holders (A) and (B).
If not, no need to fix Lead wires
in Lead wire holders (A) and (B).
Endbell complete
Put Heat sink with FET
to the place illustrated.
Heat sink with FET
Bend Connecting terminals
so that they do not touch
Heat sink.
Put Lead wires
(orange, blue, black)
of Light circuit
between Boss and Rib.
Rib
Connector
Light circuit has to be put so
that its Lead wire (orange)
connected side comes to
Terminal side.
Wiring in Housing set L
Lead wire
Line filter
holder (B)
(if used.)
Boss
Terminal
Wiring of Light circuit
Light circuit
Lead wire
(orange)
If Line filters are used, put them respectively into the places
on left side and right side of Lead wire holder (A) as follows:
1. Put one Line filter near Lead wire holder (A).
2. Put the other Line filter near Lead wire holder (B).
Lead wire
holder (A)
Switch Switch
Line filter
(if used.)r
Terminal
Line filter (if used.)
Fix Lead wire (yellow)
of Heat sink with Lead
wire holder nearest to
Switch trigger.
Fix Lead wire (blue) of
Heat sink in center
Lead wire holder.
Fix Lead wire (black)
of Heat sink in Lead
wire holder farthest
from Switch trigger.
Fix lead wires of LED job light
with Lead wire holder
LED Job light
Lead wire holder
P 17/ 17