Texas Instruments MSP430 User Manual page 47

www.ti.com
Devices MSP430FG6426, MSP430FG6425
BSL Version 00.08.08.04
RAM Erased 0x1C00 to 0x43FF
Buffer Size for Core
260 bytes
Commands
Notable Information 1. UART TX and RX BSL pins are noted in the device data sheet
Known Bugs 1. The baud rate of 115k cannot be ensured across all clock, voltage, and temperature variations.
Devices MSP430FG6626, MSP430FG6625
BSL Version 00.08.88.38
RAM Erased 0x1C00 to 0x43FF
Buffer Size for Core
260 bytes
Commands
1. Device is programmed with the factory USB BSL.
2. Factory USB BSL is RAM write only. Full BSL must first be loaded into device RAM and started to perform
flash write. Only the commands RX PASSWORD, RX DATA BLOCK FAST, and SET PC are supported
Notable Information
3. When starting this BSL from an application, the application should first de-enumerate itself, then delay
(approximately 500 ms) before starting the BSL. This allows proper re-enumeration with the host.
4. External crystal at XT2 is required to ensure USB operation.
Known Bugs
SLAU319AD – JULY 2010 – REVISED JUNE 2020
Submit Document Feedback
Table 5-27.
Table 5-28.
Copyright © 2020 Texas Instruments Incorporated
MSP430™ Flash Devices Bootloader (BSL) 47