Controls And Connections - AKA SIGNUM MFD 7272M GT Manual

Departement of international trade: https://aka-md.com | +74957991510 | akadetector@yandex.ru
are not included and must be purchased
separately. We recommend that you use
NiMH batteries from SANYO, ANS-
MANN 2500 capacity-VARTA or 2850
Ma/h. The use of standard alkaline bat-
teries is possible but not cost effective as
the rechargeable batteries pay off after 4-5
recharges.
When using batteries, with a capacity of 2500 Ma/h, continuous opera-
tion is approximately 16 hours in the main mode, 30-40 hours in econo-
my mode, 6-7 hours in Turbo mode.
The consumption of the device also depends on the operating fre-
quency of installed sensor. At high frequencies, consumption decreases,
and at low frequencies, it increases.
Several recommendations on the use of nickel-metal hydride batteries:
- Remember that due to the self-discharge nature of the batter capacity
falls (by About 5% per day, so it is advisable to charge batteries before
each use.
DO NOT
- use rechargeable batteries that have different capacities in the
WARNING!
same set.
When connecting the battery magazine to the device connector insure
the battery is properly connected (polarity is indicated on the battery
cartridge) and insure the voltage source is correct. In the case of
incorrect polarity or improper voltage the device can be damaged.

CONTROLS AND CONNECTIONS

The device can be delivered in two design options (Fig. 2). In the first
version (in the figure on the left) the option "compactness without
disassembly" is implemented due to the displacement of the middle
part of the bar into the armrest. The second option (in the figure on the
right) has a slightly lower weight and improved mechanical balance. The
company reserves the right to change and introduce new options for the
design of the device.
9