Mode "Turbo - AKA SIGNUM MFD 7272M GT Manual

Departement of international trade: https://aka-md.com | +74957991510 | akadetector@yandex.ru
This retraction of the coil in this direction must pass through the origi-
nal coordinate. Reenable the static mode. Scan the object along the line
as accurately as possible keeping a minimum distance between the ground
and the sensor. The recorded coordinate of the maximum frequency
tones sound on line B, will determine the exact location of the object.
To return to the dynamic mode press the button again

MODE "TURBO"

In the "Turbo" mode the search coil operates at the forced excitation
current.
This mode allows you to increase the sensitivity of the device and to
improve the immunity of the device from external electromagnetic
interference.
Attention! The "Turbo" mode greatly increases current consumption and as
such battery operating time is greatly reduced! The identification of shallow
deep targets also become worse due to an increase in the ground signal.
Switch to TURBO and back by using the button
while in search mode. It is necessary to ensure that the settings ST/RT
sensitivity and volume on the display screen are not displayed.
Turbo mode is enabled separately for each program.
Advice from an experienced searcher:
Remember that turning on the Turbo dramatically increases the energy
consumption of the device. And if the batteries or accumulators of your
device are discharged, after turning on the Turbo the device may display
the inscription "Battery is low" and stop working. Turning it on and off
will not help, since the device will continue to turn on in the program
with Turbo turned on, and it will not have enough voltage to work. If
you do not have spare batteries or accumulators with you, there are two
ways to solve the problem:
28