Mode "Turbo; Mode "Economy; Mode S Algorithm - AKA Signum MFT 7272? Instruction Manual

Селективный металлодетектор «Сигнум MFT» 7272М. Руководство по эксплуатации.
Then move the coil away from the target
(A) scanning (e.g. forward) along this
This retraction of the coil in this direction must pass through the original coordinate. Re-
enable the static mode. Scan the object along the line as accurately as possible keeping a
minimum distance between the ground and the sensor. The recorded coordinate of the
maximum frequency tones sound on line B, will determine the exact location of the
object.
To return to the dynamic mode press the button again
.

MODE "TURBO"

In the "Turbo" mode the search coil operates at the forced excitation current.
This mode allows you to increase the sensitivity of the device and to improve the
immunity of the device from external electromagnetic interference.
Attention! The "Turbo" mode greatly increases current consumption and as
such battery operating time is greatly reduced!
Switch to TURBO and back by using the button
necessary to ensure that the settings ST/RT sensitivity and volume on the display
screen are not displayed.

MODE "ECONOMY"

In the "Economy" the sensor operates at the minimum excitation current. This
mode allows you to improve the comfort of your search on soils with a complex and
variable salinity (for example in the surf of the beach), or at locations with extreme iron
debris.
Attention! After switching to "Economy" mode it is advised to ground balance
the device.
For reference, the detection range in this mode, when air testing a large 43cm
copper coin, such as a Victorian Penny, is approximately 35cm (10" DD coil @ 6,5-7 kHz).
Thanks to the significant reduction in the consumption of power in this mode you
can run up to 40 hours on a set of fully charged batteries.
Switching to the turbo is made through the "Extras" Menu, section "Extra
Settings""(see below).

MODE S ALGORITHM

From our experience we know that the majority of metal detectors react to flat
iron objects as nonferrous. To assist in solving this problem the specially developed S
algorithm is used to assist in properly identifying these targets.
The most effective use of this algorithm is in identifying small flat iron objects (15
cm2), such as beer caps, rusted pieces roof tin, etc., with a signal rating greater than 10.
If the device detects an object with a "questionable" non-ferrous signal (high
tone) and it has a rating over 10 then using the S-Algorithm can help to identify these type
targets.
ООО «фирма «АКА», +7(495)621-0481, http://aka.2000.ru aka_md@mail.ru
perpendicular to the primary direction
line.
while in search mode. It is
17