Why Are There No Audible Alarms When A Blocked Run Is Displayed; How Do I Save Which Runs Are Blocked - IntelligentAg RECON Troubleshooting Manual

Why are there no audible alarms when a blocked run is displayed?

Verify that the iPad is not muted with the side switch (if applicable) or that the volume is
1.
not turned all the way down. Swipe down from the top right corner of the iPad screen
and make sure that the mute
Verify that audible alarms are enabled in the app's settings.
2.
Verify that the alarm delay in the app's settings isn't set too high.
3.
If you are dual shooting, ensure that the app is configured for two products.
4.
a. Tap the settings
b. Tap Edit Config.
c. Tap on a Primary or Section number and select the correct product type. For
example, seed could be Product A and fertilizer could be Product B.
Lift and lower the implement and verify that the work switch indicator in the app changes.
5.
Restart the app.
6.
a. Double-click the Home button.
b. Swipe right until you have located the Recon Wireless Blockage and Flow Monitor
app.
c. Swipe up on the app's preview to close it.
d. Press the Home button to return back to your home screen.
e. Re-open the app.

How do I save which runs are blocked?

Take a screenshot (press the iPad's top button and Home button at the same time) of either of
the screens below. The screenshot will be stored in your iPad's photos.
•
Take a screenshot of the blockage screen (before shutting off product flow).
•
Tap the History button and take a screenshot of the list of blocked runs.
600820-000012, rev 1.4
Recon Wireless Blockage and Flow Monitor (WBFM) Troubleshooting Guide
icon does not appear.
icon.
Page 12 of 15