There Is Power To The Ecu, But The Ecu Isn't Functioning - IntelligentAg RECON Troubleshooting Manual

There is power to the ECU, but the ECU isn't functioning.

If the Power LED is on:
•
o Slow blinking LED (about one blink every 3 seconds)
1. Verify that the iPad is connected to the "IASBlockage" or "IASNetwork2" Wi-Fi
network.
2. Disconnect and reconnect power to the ECUs. Refer to the troubleshooting steps
in My ECUs are not updating correctly.
3. Restart the app.
a. Double-click the iPad's Home button.
b. Swipe right until you have located the Recon Wireless Blockage and Flow
Monitor app.
c. Swipe up on the app's preview to close it.
d. Press the home button to return back to your home screen. Re-open the app.
4. Uninstall and reinstall the iPad app.
o Fast blinking LED (multiple blinks per second)
1. A firmware update could be in progress. If the app says "Firmware update in
progress," wait for the update to complete.
2. A firmware update did not install correctly.
a. Completely close the app.
i.
ii. Swipe right until you have located the app.
iii. Swipe up on the app's preview to close it.
iv. Press the home button to return back to your home screen.
b. Disconnect power to the ECU.
c. Re-open the app.
d. Re-connect power to the ECU.
3. Make sure that you're not using an old app. Delete the Intelligent Ag (red app) or
Intelligent Ag Pro app if you have it on your iPad.
o Solid red LED
1. Disconnect and reconnect the ECU harness from the intermediary harness.
Make sure that the connection is secure and that there is no dirt impeding it.
2. Plug the ECU into a different harness. It may be an issue with the Wi-Fi module.
If the Power LED is off: Ensure there is power to the harness leading up to the ECU.
•
600820-000012, rev 1.4
Recon Wireless Blockage and Flow Monitor (WBFM) Troubleshooting Guide
Double-click the Home button.
Page 8 of 15