Why Are There No Audible Alarms When A Blocked Run Is Displayed; I Cannot Access The Setup Wizard; My Port Configuration Isn't Saving - IntelligentAg RECON Troubleshooting Manual

Why are there no audible alarms when a blocked run is displayed?

Verify that the iPad is not muted with the side switch (if applicable) or that the volume is
1.
not turned all the way down. Swipe down from the top right corner of the iPad screen
and make sure that the mute
Verify that audible alarms are enabled in the app's settings.
2.
Verify that the alarm delay in the app's settings isn't set too high.
3.
If you are dual shooting, ensure that the app is configured for two products.
4.
a. Tap the settings
b. Tap Edit Config.
c. Tap on a Primary or Section number and select the correct product type. For
example, seed could be Product A and fertilizer could be Product B.
Lift and lower the implement and verify that the work switch indicator in the app changes.
5.
Restart the app.
6.
a. Double-click the Home button.
b. Swipe right until you have located the Recon Wireless Blockage and Flow Monitor
app.
c. Swipe up on the app's preview to close it.
d. Press the Home button to return back to your home screen.
e. Re-open the app.

I cannot access the setup wizard

1. Verify that the iPad is connected to the Intelligent Ag network.
2. Verify that the app is not in demo mode.

My port configuration isn't saving

Make sure that you tap Done in the lower right corner to save your configuration.
600820-000012, rev 2.1
Recon Wireless Blockage and Flow Monitor (WBFM) Troubleshooting Guide
icon does not appear.
icon.
Page 23 of 31