My Ecus Are Not Updating Correctly - IntelligentAg RECON Troubleshooting Manual

My ECUs are not updating correctly.

Complete one of the options below to update the ECUs. Option 1 may have more downtime
from the operator, but is less labor intensive. Option 2 is usually most effective, but more labor
intensive.
Option 1:
Completely close the Recon Wireless Blockage and Flow Monitor app.
1.
a. Double-click the home button.
b. Swipe right until you have located the app.
c. Swipe up on the app's preview to close it.
d. Press the home button to return back to your home screen.
Disconnect power to the ECU by turning off the tractor.
2.
Re-open the app.
3.
Re-connect power to the ECU by turning on the tractor.
4.
Wait for the app to prompt you to update the ECUs. Tap OK to start the update. Update
5.
may take up to 20 minutes.
Option 2
OPTIONAL: Use the app to identify which ECUs haven't updated.
1.
a. Open the Recon Wireless Blockage and Flow Monitor app and tap the gear icon.
b. Tap App & Device Versions.
c. Make note of which ECUs are on an older software version than the rest of the
ECUs.
Completely close the app.
2.
a. Double-click the home button.
b. Swipe right until you have located the app.
c. Swipe up on the app's preview to close it.
d. Press the home button to return back to your home screen.
Unplug ECUs.
3.
If you identified which ECUs need to be updated in Step 1, unplug those ECUs.
•
If you don't know which ECUs need to be updated, unplug all ECUs.
•
Re-open the app.
4.
Re-plug in the first unplugged ECU and check for ECU updates.
5.
If the app prompts you to update the ECU, tap OK to start the update. The update
•
could take up to 5 minutes.
If it doesn't prompt you to update the ECU within 30 seconds, that ECU doesn't need
•
an update.
Continue to plug in ECUs and update as necessary until all ECUs are plugged in and
6.
updated.
600820-000012, rev 1.4
Recon Wireless Blockage and Flow Monitor (WBFM) Troubleshooting Guide
Page 10 of 15