Table of Contents
Advertisement
Fault
lights up permanently in the
display.
lights up in the display.
appears in the display.
During operation with steam as-
sistance, steam escapes from the
ventilation slots.
After using the steam assistance,
the cooking result is too dry or
too moist.
19.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 40-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance gets very hot.
Never touch the inside surfaces of the cooking com-
▶
partment or the heating elements while they are hot.
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
Before replacing the bulb, unplug the appliance
▶
from the mains or switch off the circuit breaker in
the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
20
Disposal
Find out here how to dispose of old appliances cor-
rectly.
20.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
Unplug the appliance from the mains.
1.
Cause and troubleshooting
The sensor is defective.
Call the after-sales service.
▶
→ "Customer Service", Page 32
Build-up of limescale in the appliance.
Run the descaling programme in full.
▶
→ "Descaling", Page 23
The power supply has been disconnected or the appliance has been switched
off during the descaling process.
Run the interrupted descaling programme in full.
▶
→ "Descaling interrupted", Page 24
Steam escapes for physical reasons.
Wait until the cooking with steam assistance ends.
▶
After the end of cooking with steam assistance, no more steam will escape
after a short time.
Steam intensity set incorrectly.
Set a higher or lower steam intensity.
▶
Place a tea towel in the cooking compartment to
1.
prevent damage.
Turn the glass cover anti-clockwise to remove it .
2.
Pull out the halogen bulb without turning it .
3.
Insert the new halogen lamp and press it firmly into
4.
the socket.
Make sure the pins are positioned correctly.
Depending on the appliance model, the glass cover
5.
may have a sealing ring. Put the sealing ring in posi-
tion.
Screw the glass cover on.
6.
Take the tea towel out of the cooking compartment.
7.
Connect the appliance to the power supply.
8.
Cut through the power cord.
2.
Dispose of the appliance in an environmentally
3.
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
Disposal en
31
Advertisement
Table of Contents
