TECOM Challenger10 Installation And Quick Programming Manual page 27

This manual describes the Challenger programming that you may need for basic
system setup. Refer also to:
• Challenger10 Programming Manual for details of Challenger system
programming via the Install menu.
Challenger10 Administrators Manual for details of Challenger programming
•
and operation via the User menu.
User menu options
As part of the basic system setup you may need to use the following User menu
options:
• Option 12, Test Input
• Option 14, Program Users
• Option 15, Program Time & Date
• Option 20, Door & Floor Groups
• Option 21, Holidays
To access the User menu:
Use the following steps to access the Challenger User menu when the Code
prompt is displayed on the bottom line of the RAS.
1. Press [MENU*].
2. Enter 4346 (default Installer code), and then press [ENTER].
3. You can now select the programming option you need from the User menu.
To access the Install menu, enter 19 (Install menu option number), and then
press [ENTER].
You can now select the programming option you need from the Install menu (see
Table 2 on page 22).
Install menu options
The Install menu options and the default settings of particular importance to
installers are listed in Table 2 on page 22.
Challenger10 Installation and Quick Programming Manual
To Access Menu Enter Code
Code:
"0"-Exit "ENTER" -Down "*" -Up
0-Exit, Menu:
Install Menu
0-Exit, Menu:
21