Yamaha EMX-100RDS Owner's Manual page 49

HOW TO USE THE BUILT-IN TIMER
CD CHANGER RECEIVER EMX–100RDS
DISC
1 2 3
STANDBY/ON
PHONES
STANDBY/ON
CD
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE REPEAT RANDOM
DISC SKIP
CENTER/REAR
TEST FLAT
/DELAY
MUSIC
LEVEL
STANDBY/ON
SLEEP
SLEEP
VOLUME
STANDBY/ON
INPUT SELECTOR VOLUME
VCR/LD-TV/CD/TUNER/TAPE•MD/AUX
OPEN/
CLOSE
DISC
CHANGE
FREQ PS/PTY/RT/CT MODE PTY SEEK START
RANDOM REPEAT TIME MEMORY AUTO/MAN'L
PROGRAM
HOUR MIN TIME ADJ TIMER
PTY SELECT PRESET/TUNING/BAND A/B/C/D/E PTY SELECT
MUSIC
MIC MIC MIXING
DISPLAY
USER MEMORY
MIN MAX
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
I0
OPEN/CLOSE TUNER
STOP PLAY/PAUSE
INPUT
PROGRAM USER
DISPLAY
Sleep timer operation
This unit can be turned into the standby mode automatically.
1
Play the desired sound source.
2
Press the SLEEP button. "SLEEP" appears on the display,
and soon it is replaced by "2h00m".
3
Press the SLEEP button repeatedly until the desired sleep
time appears on the display. The display will change as
described below. [Time is displayed by the hour (h) and
the minute (m).]
2h00m 1h30m
(Sleep timer is off.)
* The original display mode will resume about 4 seconds
after the selection is made.
* The SLEEP indicator will light up to indicate that the
sleep timer is on.
4
The unit will turn into the standby mode automatically
when the selected sleep time passes.
To confirm the sleep time setting
Press the SLEEP button once. "SLEEP" appears on the
display, and soon it is replaced by the remaining time of the
selected sleep time.
To change the sleep time
While the SLEEP indicator is illuminated, press the SLEEP
button repeatedly until the desired time appears.
To stop the sleep timer operation
Press the STANDBY/ON switch, or press the SLEEP button
repeatedly until "OFF SLEEP" appears on the display.
(The SLEEP indicator will go out.)
Using the timer and the sleep
timer at the same time
You can make a timer play setting so that the timer operates
after this unit turns into the standby mode by the operation of
the sleep timer.
1
Prepare timer play. (See pages 39 to 40)
* Do not turn this unit into the standby mode after the
timer setting is finished.
2
Press the SLEEP button and set the sleep time.
When the sleep timer operation finishes, the timer begins
functioning to turn the source on at the preset time.
Note
You cannot use the timer and the sleep timer at the same
time in any way other than described here.
E-41
1h00m 0h30m
OFF SLEEP