Table of Contents
Advertisement
Installation of BSHPS (Fabius Tiro)
Right Mount COSY BSHPS Installation
(Trolley)
1. Install the power supply onto the left rear GCX
rail of the Fabius Tiro by sliding the mounting
plate of the power supply through the opening of
the rail (1 in
Figure
Tighten the knob (1 in
when the power supply is in the desired position.
2. Route the power cable for the heater through the
trough (2 in
Figure
At the right hand end of the trough, route the
cable into the cable management cavity
(1 in
Figure
6) on the bottom of the COSY arm.
3. Plug the connector at the end of the cable into
the mating connector (2 in
underside of the COSY. Orient the connector so
that the red mark on the connector plug aligns
with the red mark on the receptacle.
10
4) and then sliding it upward.
Figure
5) against the rail
5) on the rear of the cabinet.
Figure
6) on the rear
Figure 5. BSHPS Installation on Machine with Right Mount
COSY - Step 1 (Trolley)
1
Figure 6. BSHPS Installation on Machine with Right Mount
COSY - Step 2 (Trolley)
1
2
2
Fabius GS/Tiro Supplement
Advertisement
Table of Contents
