Electrical Connection - Fisher & Paykel CG301D Installation Manual

ELECTRICAL CONNECTION

Connect the cooktop to the power
supply and attach the duplicate data
label to an accessible location.
COOKTOP BURNERS
ATTACH PAN SUPPORTS
TEST BURNERS
lifting off yellow tip
To check that the ignition system operates correctly, light each burner by itself, then all
z
burners in combination.
Check for a well-defined blue flame without any yellow tipping.
z
If any abnormality is evident, check that the components of the burner assembly are
z
located properly.
No air shutter adjustment is possible on the cooktop. Correct operation is achieved with
z
factory installed settings for the correct gas type.
When installing the burner port ring, align the two locating pins in the bottom side of the
z
port ring with the locating notch and centre holes on the top side of the simmer ring, and
make sure these are properly engaged.
Incorrect installation may produce a potentially dangerous flame and result in poor
z
burner performance.
If proper operation cannot be obtained, contact Customer Care or your nearest
z
Fisher & Paykel Authorized Service Centre.
The cooktop must not be used by the until proper operation has been achieved.
z
Securely locate all pan supports ensuring
they are the installed in the correct
orientation and do not rock.
stable blue flame
27