Related Manuals for JNJ SPAS SPA-301
Summary of Contents for JNJ SPAS SPA-301
- Page 1 OWNERS MANUAL GUANGZHOU JNJ SANITARY WARE CO., LTD. TEL：86-20-36460026 ADD：No.166, HUANGJINWEI INDUSTRIAL ZONE, SHIJING, BAIYUN, GUANGZHOU, CHINA 1 / 16...
-
Page 2: Table Of Contents
Important Safety Instruction·················4 Choosing a Location···························5 Site Preparation·································5 Installation·······································6 Control System Instruction····················8 Spa Care and Maintenance····················9 Water Quality and Maintenance··············11 Appendix········································15 PRODUCT PAREMETERS Model SPA-301 Serial Number 380×240×995cm Dimension: Dry Weight: 510 kg Structure 86.6×76.8×39inches Index 3100 Liters Total Weight Filled... -
Page 3: Introduction
INTRODUCTION Your choice of spa indicates that you are devoted to excellence. The manufacturer appreciates your patronage and takes pride in the tradition of quality spas that our company represents. we are confident that your new spa will provide you, your family and friends, with years of enjoyment and fulfill all your hydrotherapy needs. -
Page 4: Important Safety Instruction
IMPORTANT SAFETY INSTRUCTIONS When installing your spa and using this equipment, basic safety precautions should always be followed. The following instructions are required by IEC 60335-1 standard. They contain important safety information we strongly urge you to read and apply. For your safety and the safety of others, it is vital that the following be mentioned: ... -
Page 5: Choosing A Location
HYPERTHERMIA Prolonged immersion in water that exceeds normal body temperature can lead to hyperthermia. Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal body temperature of 98.60° F (37.0° C). The symptoms of hyperthermia include drowsiness, lethargy, and an increase in the internal temperature of the body. -
Page 6: Installation
Install so as to permit access to the equipment, either from above or below, for servicing. Make certain that there are no obstructions which would prevent removal of the cabinet side panels and access to the inner components. Above-ground Installation For best results, we recommend the installation of a level concrete pad: ... - Page 7 NOTICE: Make sure that there is sufficient assistance to gently slide the spa off the dolly or cart to the support base without any damage. Damage caused during transportation or by improper handling is not covered by the factory warranty. Installation Instructions ...
-
Page 8: Control System Instruction
CONTROL SYSTEM INSTRUCTION NOTE: The function and connection of the controller meets the corresponding model of controller manual. The function and parameter of the spa meet the APPENDIX. Display Message Message Meaning Action Required No message on display. Power has been cut off The control panel will be disabled until power returns. -
Page 9: Spa Care And Maintenance
Periodic Reminder Messages Press the “Mode” button to reset a displayed reminder. Message Frequency Action Required Every 7 days Test and adjust pH chemical levels (see pages 11-13) Every 7 days Test and adjust sanitizer chemical level (see pages 11-13) Every 30 days Remove, clean and install filter (see page 10) Every 30 days... - Page 10 Sodium bicarbonate (baking soda) can also be used for minor surface cleaning. Always thoroughly rinse off any spa shell cleaning agent with fresh water. NOTICE: Most household chemicals are harmful to your spa shell. Iron and copper in the water can stain the spa shell if allowed to go unchecked. Ask the local dealer about a stain and scale inhibitor to use if your spa water has a high concentration of dissolved minerals.
-
Page 11: Water Quality And Maintenance
Leave the drain open. Close the spa cover and fasten with tie down safety locks. WATER QUALITY AND MAINTENANCE The quality of the water in your spa is important and must be kept clean. Your program will vary depending on your water’s mineral content, and how often you use your spa, and the amount of people using it. - Page 12 Carefully measure the recommended amount of chemical and slowly pour it into the filter compartment. Use care not to splash chemicals on your hands, eyes, or on the spa shell surface or cabinet. Replace filter lid and run spa for 10 minutes on high speed. Re-install spa cover. NOTICE: After administering a super chlorination treatment or non-chlorine shock to your spa, leave the cover open for a minimum of 20 minutes to allow the oxidizer gas to vent.
- Page 13 4) The filter cartridge pores may become obstructed. METHOD: If the pH level is too low, it can be increased by adding pH/Alkalinity Up (sodium hydrogen carbonate) to the spa water If the pH is too high, it can be decreased by adding pH/Alkalinity Down (sodium bisulfate) to the spa water.
- Page 14 Musty Odor Bacteria or algae growth Shock spa with sanitizer – if problem is visible or persistent, drain, clean and refill spa. Organic buildup / scum Build-up of oils and dirt Wipe off scum with clean rag- if severe, drain ring around spa the spa, use a spa surface and tile cleaner to remove the scum, and refill...
-
Page 15: Appendix
APPENDIX : 15 / 16... - Page 16 16 / 16...
Need help?
Do you have a question about the SPA-301 and is the answer not in the manual?
Questions and answers