Fault Codes - Xerox SquareFold Trimmer Module User Manual

SquareFold Trimmer Module

Fault Codes

If a jam/fault occurs in the SquareFold Trimmer Module, the machine's UI displays a jam/fault message. The following
table provides a list of fault codes for the SquareFold Trimmer Module and a list of related finisher fault codes.
Tip
The top covers cannot be opened during normal operation or when the machine is idle. The covers can be opened only
when an indicator is lit (refer to page 4) and a jam/fault occurs within the SquareFold Trimmer Module.
Fault code
Jam/fault with the SquareFold Trimmer
Module
User Guide
Possible cause Recommended solution
1. Open the Top Left and Right Covers of the SquareFold
Trimmer Module.
2. Carefully remove all sheets and paper scraps from jam
clearance areas.
3. Close the SquareFold Trimmer Module Top Left and Right
Covers.
4. Check the Trimmer Waste Container:
• If full, empty the container and reinsert it into the
SquareFold Trimmer Module.
• If the container is partially pulled out, push it
completely in.
5. If necessary, follow any remaining instructions on the
machine's UI.
6. If fault persists, repeat Steps 1-5; if fault persists after that,
call for service.
Problem solving
17