Table of Contents
Advertisement
4-3
•
62
Chapter 4
Control Panel Button
The control panel button is used for many purposes, for example, to
pause/resume job processing, reset printer parameters, print status
page, or show the detail of fatal hardware errors.
The following table shows the effect of pressing the button under certain
conditions and for certain durations.
Condition
Ready
Momentary
10 seconds
In use
Momentary
Power-up
At power up
until all LEDs
double blink
During printing
Held down at
job
least 4
seconds
Pause/Off-line
Momentary
Printer functions associated with the Control Panel Button are not
executed until you release the buttons.
Duration
Takes the printer off-line (Pause/Off-
line status)
The printer will print a settings page
which shows printer parameters.
Takes the printer off-line (Pause/Off-
line status) and execution of any job
will be withheld until the button is
pressed again.
Causes reset of non-volatile
parameters to the factory default
values. The printer will first enter onto
the Diagnostic Processing status,
then all LEDs will start to double blink.
When this happens, release the button,
and LEDs will indicate the Initializing
status. Then, it goes to the Ready
status.
Resets the printer. All printing jobs will
be canceled. Light will cycle through all
LEDs as it does during Initializing
status until button is released. Then,
the printer goes to the Ready status.
Resumes printing from pause; or go to
Ready status from Off-line status.
Effect
Advertisement
Table of Contents
