Sym HD2 125 Service Manual page 92

Transistor ignition coil
First circuit coil
resistance
measurement
Crankshaft position sensor
Long tooth
Measurement resistance value
To this chapter contents
Functional Description:
Use 8 ~ 16V DC power supply, has the two-pin socket.
●
Two-pin socket for the power supply and grounding. Its main
●
components for the high conversion ratio transformer.
Through computer programs when the ignition is controlled, from
●
ignition timing (TDC) / crank position sensor, the throttle valve position
sensor, engine temperature sensor, the inlet pressure sensor and O
Sensor, issued by the signal, with the engine Speed through the ECU
to determine the appropriate ignition is, by the current of a crystal
intermittent control, a 25000-30000 volts of secondary hypertension,
flashover triggered spark plug, this approach will not only enable the
engine to achieve maximum output function, also help to improve the
efficiency of fuel consumption and pollution improvements.
Testing Procedures:
Resistance Confirmation:
Removed coil first circuit plugs on the ignition coil (Red / Yellow &
●
Black / Yellow).
Use of the "meter" Ohm stalls (Ω), measurement of the ignition coil
●
resistance value.
Detection judge:
Ignition coil primary circuit:
●
Treatment of abnormal phenomena:
1. Ignition coil internal coil disconnection damaged, or plugs bad contact.
2. Ignition coil ignition is not abnormal, proposes to replace the ignition
coil.
Functional Description:
Do not need for an external power supply, has two-pin of signal plug.
●
Constitutes a major change in its reluctance induction coil.
●
The spacing of flywheel and sensor should be 0.7 to 1.1 mm.
●
Magnetic induction sensor is the use of flywheel on the Gear (23 +1
●
long tooth) rotary cutting induction coil changes in the magnetic field
sensor with the inductive voltage signal for ECU judgement, calculated
at the engine speed and crankshaft position, and with a most
appropriate time of fuel injection and ignition control.
Testing Procedures:
Resistance Confirmation:
Removed crankshaft position sensor coupler (Blue / Yellow & Green /
●
White).
Use of the "meter" Ohm stalls (Ω), measurement of the crankshaft
●
position sensor resistance value.
Detection judge:
Resistance value: 80~160Ω(20ºC)
●
Treatment of abnormal phenomena:
1. Sensor internal coil interrupted damaged, or coupler bad contact.
2. Check whether the abnormal wire harness lines.
3. Sensor coil anomaly, the proposed replacement of the new one.
5. Fuel Injection System
2.8Ω±15% (20ºC)
2
5-29