Engine Hanger Bush Removal - Sym HD2 125 Service Manual

To this chapter contents
6. ENGINE REMOVAL

Engine Hanger Bush Removal

Bush
Check if engine hanger bush and cushion rubber
bush for damage.
Pressing out
If engine hanger and the rear cushion rubber bush
damaged. Then, with the bush remover / presser,
Ø 30mm & Ø 22mm, to press the bush out, and
replace it with new one.
Engine hanger bush: ψ 30mm
ψ 22mm
Rear cushion bush:
Place the detent section of the bush remover
toward the bush, and drive both the pressing ring
and bolt in to press the bush out.
Pressing In
Place the flat section of the remover toward the
bush, and then drive the bush, pressing ring, and
bolt in to install the bush.
6-6