Tru-Turf RS48-11D Manual page 16

Maintenance Maintenance
• If bearings are faulty
(a) Remove the complete smoothing head from the
machine, undo the four swivel mount bolts on
upper body and steering rod, wheel the roller away
until the total head is exposed to work on.
(b) Remove roller shaft bolts from end plates, remove
rollers from the heads.
(c) Fit new bearings, replace rollers into the heads,
lubricate shaft bolts with an anti seize compound
before installing them. Tighten securely and ensure
rollers rotate freely when fully tightened.
or
If the rollers are a sealed type remove the roller and
replace with a complete new roller.
(d) If the rods are removed or lengths altered ensure
they are correctly adjusted so that the three heads
are parallel to each other when in the straight
ahead position. Adjust if necessary.
Changing engine oil
• Change oil and service as per the manufacturers
Servicing Schedule enclosed as a separate insert to
this manual.
13
Changing transmission oil
Ongoing Maintenance, Lubricant and Replacement
Schedule (below)
Note. Areas indicated with a * need to be changed
when defective or as required. This may be before the
recommended replacement schedule. Please replace all
parts as necessary.
Description
Check Engine oil
Check Transmission Oil Level
Beware of contaminants entering the transmission
Lubricate drive chain with WD40 or equivalent
Check Tires Max 18 P.S.I.
Check Gas
Check Smoothing Roller Bearing
Check Drive Roller Bearings
Check for loose Nuts and Bolts
Renew Engine Oil
Renew Transmission Oil - See page 1 for correct oil
Renew Transmission Oil Filter
Renew Smoothing Roller Bearings
Renew Drive Roller Bearings
Renew Chain Tensioner Sprocket Bearings
Renew Drive Chain
Replace Foot Pedal Struts
Replace Trailer Strut
TRU-TURF RS48-11D USA Roll 'n' Spike & RS48-11DB Golf Greens Roller Manual
Pre-Delivery Pre-Operating 12 Monthly
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
as per manufacturers Handbook
√
every 500hrs or...
* √
* √
* √
* √
* √
*
*