Download  Print this page

Using The Finisher; Stapling Options - Xerox DocuColor 12CP User Manual

For document centre color series 50 and docucolor 12
Hide thumbs

Advertisement

Using the Finisher

The Finisher can staple from 2 to 50 sheets (50-sheet maximum applies to up to 24 lb/90
gsm paper). You can staple both portrait and landscape documents with single or dual
staples. Output to the Finisher Output Tray is delivered face down.
Jobs containing more than 50 sheets will not be stapled.
Paper Tray 5 cannot be selected as the paper source for a stapled job.
Refer to the "Technical data" section of this guide for complete stapling specifications.
NOTE: The procedures in this section apply to the Document Centre ColorSeries 50
copier/printer only. To use the Finisher options on the DocuColor 12 copier/printer, refer to
the product manual supplied by the manufacturer of the Digital Front End connected to
your DocuColor 12.

Stapling options

Stapling options are selected from your printer driver and depend on the paper size
selected. The table below shows the typical stapling options along with an example of the
finished output for 8.5 x 11 or A4 paper.
1 Staple Portrait
1 Staple Landscape
2 Staples Portrait, Long Edge
2 Staples Landscape, Long Edge
2 Staples Portrait, Short Edge
2 Staples Landscape, Short Edge
IN-LINE STAPLER FINISHER USER GUIDE
Printer driver selection
Table 1: Stapling options
Finished example
F
F
F
8.5 x 11
A4
F
F
F
F
9

Advertisement

Table of Contents
loading

  Also See for Xerox DocuColor 12CP

  Related Manuals for Xerox DocuColor 12CP

This manual is also suitable for:

In-line stapler finisher