Xerox 4520 User Manual page 102

I n t e r f a c e M e n u
Figure 3.13 Serial Menu options showing factory settings (continued)
Option
Auto Job End
3-48 4 5 2 0 / 4 5 2 0 m p U s e r ' s G u i d e
Setting
Off
On*
Description
Automatic ending of a print job that does not finish.
When On, after the current print job has paused long
enough to exceed the Port Timeout (page 3-46)
interval and no data has been received on any other
port, the print job will be stopped. Any partial page is
ejected from the printer and the print job is cleared
from memory.
Use Auto Job End On when the printer serves
multiple users on a network. This assures that one
user's print job will finish and all pages will exit the
printer whether or not another user sends a print job.
No partial pages will be left unprinted.
When Off, the print job does not end after the
timeout interval. Instead, the printer waits to continue
until another print job is received on any port. A
partial page will remain unprinted until the next print
job is received. See Form Feed
information on ejecting partial pages.
Auto Job End should be On if the printer
is on a network.
Note
If you are not sharing the printer with other users and
if you find that one page is split and printed on
multiple pages, set Auto Job End Off or increase the
Port Timeout interval. It could be the Port Timeout
is exceeded before the rest of the page can be sent.
Also see "Printer Settings that Affect Memory"
(page 3-69) for other ways to correct the problem of
one page printing on multiple pages.
With the Hard Disk option installed and
Disk Spooling On, Auto Job End is always
on (regardless of setting).
Note
(page 3-5) for