Laser Safety Information; For Consumables; Product Safety Certification; Regulatory Information - Xerox PHASER 3435 User Manual

Laser Safety Information

CAUTION:
Use of controls, adjustments or
performance of procedure other than those specified
herein may result in hazardous light exposure.
With specific regard to laser safety, the equipment complies with
performance standards for laser product set by government,
national and international agencies as a Class 1 laser product. It
does not emit hazardous light, as the beam is totally enclosed during
all phases of customer operation and maintenance.

For Consumables

• Store all consumables in accordance with the instructions given
on the package or container.
• Keep all consumables away from the reach of children.
• Never throw print cartridges or toner containers into an open
flame.
• Cartridges: When handing cartridges, for example ink, fuser,
etc, avoid skin or eye contact. Eye contact can cause irritation
and inflammation. Do not attempt to disassemble the cartridge.
This can increase the risk of skin or eye contact.

Product Safety Certification

This product is certified by the following Agency using the Safety
standards listed.
Agency
Underwriters Laboratories Inc.
SEMKO
This product has been manufactured under a registered ISO 9001
Quality system.

Regulatory Information

CE Mark
The CE mark applied to this product, symbolizes XEROX's
declaration of conformity with the following applicable European
Union Directives, as of the dates indicated:
December 12, 2006:
Standard
UL60950-1st Edition (2003) (USA/
Canada)
IEC60950-1st Edition 1 (2001)
Council Directive 2006/95/EC as amended. Approximation of the
laws of the member states related to low voltage equipment.
December 15, 2004:
Council Directive 2004/108/EC as amended. Approximation of the
laws of the member states related to electromagnetic compatibility.
March 9, 1999:
Council Directive 99/5/EC, on radio equipment and
telecommunications terminal equipment and the mutual recognition
of the conformity.
A full declaration of conformity, defining the relevant directives and
referenced standards, can be obtained from your XEROX Limited
representative.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
WARNING:
equipment not specifically approved by the Xerox
Corporation may void the user's authority to operate
this equipment.
WARNING:
equipment to maintain compliance with FCC
regulations.
iii
Changes or modifications to this
Shielded cables must be used with this