Fn: Setting Custom Functions; Other Applications; Zooming Function; Sync Triggering - Godox AD300Pro Instruction Manual

The Reason & Solution of Not Triggering in Godox 2.4G Wireless
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless base station, 2.4G wifi router,
Bluetooth, etc.)
→ To adjust the channel CH setting on the flash trigger (add 10+ channels) and use the channel which is not
disturbed. Or turn off the other 2.4G equipment in working.
2. Please make sure that whether the flash has finished its recycle or caught up with the continuous
shooting speed or not(the flash ready indicator is lighten) and the flash is not under the state of
over-heat protection or other abnormal situation.
→Please downgrade the flash power output. If the flash is in TTL mode, please try to change it to M mode(a
preflash is needed in TTL mode).
3. Whether the distance between the flash trigger and the flash is too close or not
→Please turn on the "close distance wireless mode" on the flash trigger (＜0.5m):
X2 & X1 series: press the test button and hold on, then turning it on until the flash ready indicator blinks for 2
times.
XPro series: Set the C.Fn-DIST to 0-30m.
4. Whether the flash trigger and the receiver end equipment are in the low battery states or not
→Please replace the battery(the flash trigger is recommended to use 1.5V disposable alkaline battery).
C.Fn: Setting Custom Functions
The following table lists the Available and unAvailable custom functions of this flash.
Custom Function Functions Setting
Signs Signs
F1 Beeper ON
OFF
F2 S1/S2 mode OFF
selection S1
S2
F3 Auto standby OFF
30 min
60 min
90 min
F4 Delay flash OFF,
0.01~30s
F5 Mask OFF
n1
n2
F6 t0.1 display ON
OFF
F7 ID Setting OFF
01-99
F8 Stable Color OFF
Temperature ON
Mode
Settings & Restrictions
Descriptions
ON NO
OFF
OFF M mode
S1 mode
S2 mode
OFF NO
Auto standby
without
any operation
Can be triggered M/Multi mode
as second curtain
OFF M mode
ON: Trigger 2 times
for 1 cycles,
1th flash of trigger.
ON: Trigger 2 times
for 1 cycles,
2th flash of trigger.
Display M mode
Not display
OFF Wireless mode
Choose any figure from 01-99
OFF M non-high-speed
ON mode
- 37 -
1. Press the <MENU> button to enter the C.Fn meun.
2. Select the custom function No.
● Turn the SET Selection Dial to select the custom function No.
3. Change the setting
● Press < SET > button and the Setting No. blinks.
● Turn the SET Select Dial to set the desired number. Press < SET > button will
confirm the settings.
4. Exit C.Fn menu
● Press < MENU > button to exit.

Other Applications

Zooming Function

Separately purchase a S2 bracket to achieve
zooming function.
When installed onto the S2 bracket, AD300Pro
can move back and forth to achieve zooming
function and gain spotlight or diffused effects.

Sync Triggering

The Sync Cord Jack is a Φ3.5mm plug. Insert a trigger plug here and the flash will be
fired synchronously with the camera shutter.
- 38 -