Table of Contents
Advertisement
Problem
The appliance is
noisy and generates
abnormal sounds.
The side or front of
the appliance is
warm.
The bottom side of
the product is warm
or there is warm air
coming from the
back.
The internal wall of
the product is warm.
Clicking noises
36
36
Possible Causes
Is the appliance installed on a
weak floor or improperly
leveled?
Does the rear of the appliance
touch the wall?
Are objects scattered behind
the appliance?
Is there an object on top of the
appliance?
There are anti condensation
pipes fitted to these areas of
the appliance to reduce
condensation forming from
around the door area.
Did you install the product not
too long ago?
Did you touch it when the
product is operating?
The defrost control will click
when the automatic defrost
cycle begins and ends. The
thermostat control (or
appliance control on some
models) will also click when
cycling on and off.
Solutions
• Install the appliance on a solid and
flat area.
• Adjust the installation position to
allow enough clearance around the
appliance.
• Remove the scattered objects from
behind the appliance.
• Remove the object on top of the
appliance.
• The heat releasing pipe to prevent
condensation is installed on the front
and side of the appliance. You may
feel it particularly hot right after the
appliance is installed or during the
summer. You can be assured that
this is not a problem and is quite
normal.
• Right after installation, the
compressor will operate very hard to
cool it down quickly. So, you can
expect warmth or warm air at the
bottom right.
After cooling down, the warm air will
be gone. So do not worry.
• To maintain the optimal temperature,
the cold air and the hot air will take
turns to control the temperatures,
causing the inner wall to be warm. It
is not a malfunction, so keep using
the product as usual.
• Normal Operation
EN
Advertisement
Table of Contents
