Reinstall The Base Grille; Complete Installation - KitchenAid KDDA27TRS Installation Manual

Double refrigerator drawers
Table of Contents

Advertisement

Available languages

Available languages

Reinstall the Base Grille

1. Be sure the Power On/Off Switch is on.
A
A. Power On/Off Switch (ON)
2. Reinstall the base grille.
NOTE: The bottom of the base grille has a notch and a wider
flange than the top.
A. Bottom flange
3. Using a Phillips screwdriver, drive the four screws into the
base grille as shown. Tighten all screws.
A
A. Screws
1. Remove all boxes, parts packages and packing materials
2. Remove the protective film.
3. Clean the refrigerator drawers before use. See "Cleaning"
4. The controls are preset at the factory to the default setting
5. If construction will continue after the refrigerator drawers
To get the most efficient use from your new refrigerator drawers,
read your Use & Care Guide. Keep these Installation Instructions
and Use & Care Guide near the refrigerator drawers for easy
reference.
A
A

Complete Installation

from the interior of the refrigerator drawers.
section in the Use & Care Guide for instructions.
37°F (3°C) for the upper and lower drawers. Be sure that the
compressor is operating properly and that all the lights are
working.
have been installed, turn the power Off for both Drawers. See
"Using the Controls" in the Use & Care Guide for instructions.
11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KDDA27TRS and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Kddo27trx

Table of Contents