Walkin’ Pets Front Wheel Attachment Assembly Instructions

For walkin’ wheels mini

Download this manual

Walkin' Wheels MINI Front Wheel Attachment

The Walkin' Wheels Front Wheel Attachment gives mobility to dogs with front leg weakness or weakness in all

four legs. It is ideal for helping disabled pets get exercise and for rehabilitation while they are healing. Like the rest

of the Walkin' Wheels products, the Front Wheel Attachment is adjustable, so it will ﬁt the Walkin' Wheels

wheelchair for any size dog from 2 to 10 pounds and can easily be removed at any time.

Note: Your dog's fold of ﬂank rear leg measurement determined the Front Wheel Attachment

size you received.

Front

leg rings

Assembly Instructions

What's in the B2 or B3 Front Box:

Knuckle

Strut

Stabilization bar:

for B2 only

Adjustment

knob

Caster mount

Caster wheels

Clamps for

leg rings

Page 1 Assembly Instructions The Walkin’ Wheels Front Wheel Attachment gives mobility to dogs with front leg weakness or weakness in all four legs. It is ideal for helping disabled pets get exercise and for rehabilitation while they are healing. Like the rest of the Walkin’...
Page 2 Set-up for Rear Mini Walkin’ Wheels (This must be done ﬁrst) 1. Remove the rear clamps, leg rings, and front harness. 2. Remove adjustment knob and small washer from the knuckle. 3. Pull out the strut/wheel assembly. 4. Remove both sides of the black round knuckle. 5.
Page 3 1. Remove the adjustment knob on the knuckle, holding the bonded knuckle together in one piece, remove bolt and washer. Attach knuckle to the center of the slot on the side extender. Keeping the knuckle together in one piece, should insure the correct angle for caster mount and wheel. (caster mount should always be parallel to ground).
Page 4 In the BF1 Package The Front Wheel Attachment is easy to assemble. You won’t need any tools. The package contains: Knuckle Front Adjustment leg rings knobs Clamps for leg rings (8) Caster wheels Diagram 3 (for B1) Knuckle Knuckle Bolts...